sub routine acramatic 950 - CNCzone.com-The Largest Machinist Community on the net!

PETE1968 · #1 11-30-2009, 10:36 AM

i got a large program that the controls segments in the memory then calls the segments to active memory as needed. my ? is can you run a sub routine with a segmented program. THe program being called is segemented. I have been getting a ENS not found error code but the ENS is at the end of the SUB ROUTINE. I think the segmented program is causing the conflict.

beege · #2 11-30-2009, 10:47 AM

Very long time since I ran an Acramatic, and that was an 850SX. Post your code? I think it's format was:

(ENS,)

But that's how long its been.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
help with sub-routine programing	accramachine	G-Code Programing	30	11-13-2009 07:34 AM
Sub Routine	ynnek	TurboCAD/CAM	1	09-18-2009 07:01 AM
Need Help!- program exit sub routine	MMTechi	G-Code Programing	3	06-11-2009 04:51 PM
Activating HPCC in a sub-routine?	Dawson	Daewoo/Doosan	0	03-18-2006 02:04 PM
3D surface sub-routine	lazza	G-Code Programing	2	08-30-2005 08:58 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)