GE Mark Century 2000 programming manual needed.

[cncservices]

Any advice on a source for a GE Mark Century 2000 programming manual would be greatly appreciated.

Thanks in advance.

Have a good day,

Jim

[mnamfg]

Hi Jim, Do you need one for a milling control or for a lathe control? I believe I have on for the milling controls and might be able locate one for lathe programming.
Mark

[cncservices]

Hi Mark,

The lathe manual is needed. The control is attached to a Warner Swasey chucking lathe. Even a mill manual would be helpful because it would at least help with the navigation of the screens.

Jim

[mnamfg]

Hi Jim,
You are in luck, I have located a programming manual for GE2000T controls. I am new to this site so I guess you can just post back or if you want to give me a call at 814-254-6644. Thanks, Mark

[tenjtenj]

Jim, Would you part with a copy of your GE 2000t Programming Manual. I just picked up a Warner-Swasey lathe with the GE 2000T control and the programming manual was missing. I was hoping you would still have your copy.
Jef