Books/Reference material recommendations - CNCzone.com-The Largest Machinist Community on the net!

DeadTom · #1 07-20-2009, 03:12 PM

I am new to gcode and would like some recommendations on books, reference materials, websites, etc.

Thank you,
Tom L.

jpinzan · #2 07-20-2009, 04:45 PM

Try this book:
CNC Programming Handbook, Third Edition by Peter Smid (Hardcover - Nov 26, 2007)

is good. lots of information, cd, examples.

DeadTom · #3 07-21-2009, 02:44 PM

Thank you, I have located the book on Amazon and can have it on my doorstep in one day for $60. And that is with free shipping, used books retail around $50.

Thanks,
Tom L.

SCRAPWOTSCRAP · #4 07-21-2009, 03:10 PM

You might want to check this out:

http://www.cnczone.com/forums/showthread.php?t=15358

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
recommend camworks reference material?	gvidas	CamWorks	3	12-20-2010 08:14 PM
Need to make some stamps. Recommendations for material	laka	General Metalwork Discussion	1	01-18-2009 02:41 PM
Reference Table for Steel Material	nearbeer	Mechanical Calculations/Engineering Design	1	10-08-2008 06:08 PM
~* Books for Pro-E ~*	AhmedMoulds	General CAM Discussion	3	05-22-2007 03:00 AM
Books	CRS	Suggestions for the CNCzone.com site.	5	05-08-2007 05:20 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)