i can't work out the logic for this type of program, any suggestions? - Page 2 - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > Machine Controllers Software and Solutions > G-Code Programing
i can't work out the logic for this type of program, any suggestions?

G-Code Programing Discuss G-code programing and problems here!

This forum is sponsored by:

Page 2 of 2

#13

02-06-2005, 08:08 PM

Join Date: Sep 2004

Location: Australia

Posts: 196

We received in the mail the remainder programming manuals, damn that made it easier, the command to round up is #6=FUP[#5]

Thanks alot guys.

Page 2 of 2

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
parametric programming	Karl_T	CamSoft Products	21	05-24-2005 02:58 PM
Need Program Suggestions... Help	elalto	General CAM Discussion	1	08-12-2004 03:09 PM
G codes	Citron	CamSoft Products	14	06-10-2004 10:59 PM
My work in progress, suggestions welcome!	freezer	DIY-CNC Router Table Machines	5	02-15-2004 08:11 PM

All times are GMT -5. The time now is 12:17 AM.