Engrave center of font - Page 2 - CNCzone.com-The Largest Machinist Community on the net!

MrBean · #13 02-28-2005, 08:19 PM

Ooops. Didn't see your post, Ger21. It was on the next page. Doh.

47MLB · #14 03-05-2005, 12:53 AM

Originally Posted by ger21

Check if your I,J is set to incremental. It's in Configure>State.

Thanks Ger21 it was the I,J incremental for circles not ther whole program there is two choices.
47MLB

foamcutter · #15 03-05-2005, 03:11 PM

Can you direct me to where to get this millwrite 2000 and at what investment? Thanks

Never mind I found it. Once again 30 seconds after asking a question I find the answer. Thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How do I engrave numbers...	slp_prlzys	DIY-CNC Router Table Machines	7	10-15-2004 02:35 PM
OpenSource CNC Design Center License	CNCadmin	Opensource Forum Rules	0	08-13-2004 09:39 PM
G1005 CNC Conversion Ballscrews	Noah	General Metal Working Machines	11	03-02-2004 02:24 PM
Font Question	BeerFizz	DIY-CNC Router Table Machines	5	02-14-2004 09:57 AM
Find the center of a circle	Hobbiest	WoodWorking	7	01-27-2004 11:24 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)