Need Help!- G CODEs FOR FANUC 10T

[suhasamlock]

Kindly give me G COde explanations like

For 10t,11t and15t a one line multiple repetive cycle variant is used;
X= minor diameter
Z=end point of chaseI
I = taper over length of thread
K=single depth of thread
D=depth of first pass
A=angle of thread
P=infeed type

G97S700M03;
G0 X ( rapid point in X larger than major diameter) Z (rapid in Z)M08 (coolant on);
G76 X (minor diameter) Z (end point of chase) I (taper if needed) K (height of thread)
D (depth of 1st pass) A (angle of thrd) P (infeed method)

You can also use the standard thread cutting canned cycle G92, you rapid to your start point as above, then in the next line state;

G92 X (depth of first pass) Z (end of chase) F (feed rate = pitch)
X (depth of 2nd pass)
X (depth of 3rd pass)