| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| G-Code Programing Discuss G-code programing and problems here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-17-2008, 01:32 PM
| |||
| |||
Not sure where to poste my questions...Anyone have an idea why a fanuc 0T would give us a 005 error when we run this program; % O1000 POPEN DPRNT[CS] PCLOS M30 % The manual says: If this is an alarm, Program Errors -005- the Fanuc book says: No Data After Address - The address was not followed by the appropriate data but was followed by another address or EOB codes; modify the program. I am trying to get data to be sent out the RS232 port when this runs. Thanks in advanced for any help!
__________________ Greg Mercurio -Shop Floor Automations www.shopfloorautomations.com /619-461-4000  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fanuc Alarm 440 | jlwright | Fanuc | 6 | 03-14-2009 12:10 PM |
| Need Help!- fanuc op alarm | jaimeeduardo | Fanuc | 1 | 10-14-2008 09:59 PM |
| Need Help!- Fanuc Oi-MB-PMC Alarm | BKCOM | Fanuc | 3 | 05-13-2008 01:16 AM |
| alarm 408 servo alarm "serial not RDY", αP18 fanuc mtor code | sting | Fanuc | 0 | 01-01-2008 09:03 AM |
| fanuc 906 alarm | ezzhhh1 | Fanuc | 6 | 11-27-2007 10:02 AM |
| | |
Linear Mode
