Newbie- 3D profile in NC.

[scrapper400]

Firstly hi to all. This is my first post so sorry if I'm asking any stupid questions.

I'm currently trying to run an NC program on our Hurco VM1 and thought this forum is probably most relevant. I need to make a mold for a lens out of aluminium and so have entered a profile on the YZ plane. My plan is to sweep this profile through 360deg. However as I'll be using a 0.2mm end mill I have to put in a large number of pecks to machine this profile out but I haven't managed to find a way to introduce pecks using a subprogram. Here is the short program so far,

S%
G21
T03 M06
S8000 M03 M08
P1111 M98
M02

O1111
G0 X0 Y0 Z10
G01 Z-4.04123 F200
G19 X0 Y0
G03 Y21.2 Z-2 R110
G01 Z-4.0412
G03 Y29.88 Z-2
G0 X0 Y0 Z10
M99

Can anyone tell me how I would put a series of peck cycles in so I can peck down 0.1mm along the profile and enter a finishing profile?
Is it possible for me to then nest this program inside another sub program so that it can machine the profile then sweep around 360deg in increments of 1deg and repeat the profile each time.

I have been searching through the help functions but I'm afraid as I beginner I'm getting over whelmed with the volume of info. I'm picking up the NC language but it's slow going with the more complex stuff.

I hope someone can help.

Best regards,
Scrap.