M01 Help needed

[tturnbull50]

Is there a parameter that allows the machine to restart the spindle etc. after a M01, as the machine I am currently using does not, but another one does.

[stevo1]

What kind of control are you using??

I have not come across any parameter that will enable this. I have come across the same problem on 2 Fanuc 15 controls 1 works 1 does not. I just have a M3 command in after the M1's. I think that this is all determinded by the MTB. I could be wrong.

Stevo

[tturnbull50]

Stevo thanks for the prompt reply already doing it just wondered when the other machines dont require it, got another problem with tool change, on another forum, thanks again

[tturnbull50]

Fanuc 18 model B

[stevo1]

Is that regarding the 18m on tool change recovery?

Stevo

[tturnbull50]

Yes, during tool change when machine crashes tool recovery states move to tc Zero but actually moves to Machune zero difficult to remove tools from arm during this, service engineer doesnt know why it moves to machine zero instead of tc zero????

[cnc-king]

Is there a parameter that allows the machine to restart the spindle etc. after a M01, as the machine I am currently using does not, but another one does.

it is not a parameter but a keeprelay that allows the fanuc control to do that but then again it is up to the machine builder which keeprelay they decide to use