G19 and G16 simultaneously - CNCzone.com-The Largest Machinist Community on the net!

geodudi · #1 06-03-2008, 07:48 PM

How can i make G01 in polar coordinate but in the YZ plane. I made this but it's not working.

% O0001
N10 G17 G21 G40 G80 G98
N15 T1 M06
N16 S5000 M03
G90 G00 G54 X0. Y0.
G43 H1 Z0.
G19
G16
G01 Y10. Z45. F90.
G15
G17 M05
N120 G00 G91 G28 Z0.
N121 G28 X0. Y0.
N125 G90
N130 M30
%

beege · #2 06-04-2008, 07:23 AM

Did you look in your control manual for coding format for polar? If I remember, an E word is for the angle (your Z45.?)....or was it an R word? Been so long...

dcoupar · #3 06-04-2008, 08:22 AM

Try this:

% O0001
N10 G17 G21 G40 G80 G98
N15 T1 M06
N16 S5000 M03
G90 G00 G54 X0. Y0.
G43 H1 Z0.
G19 G90 G16
G01 Y10. Z45. F90.
G15 G00
G17 M05
N120 G00 G91 G28 Z0.
N121 G28 X0. Y0.
N125 G90
N130 M30
%

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)