G73-g83?

[metalman]

Hello Nanker if you are still having problems it is because you have a decimal point in the .250 for the q the fanuc ot control for the g74 cycle should look like this

g74 r.1
g74z-1.75 q2500 f.005

when you program fanuc ot controls it is usually 2 lines of code your first line is your retract line and your .250 pecks is written without a decimal this is one of the quirks with the fanuc ot control if this works for you let me know and I can help you with any of the canned cycles

metalman

[hatchmar]

we have a shop full of Miyanos and none of the came with the G83 cycle. they actually want extra $$ for the G83 ability- go figure. I just made up an excel spreadsheet with a function where i ender the start and finish points. then i just copy and paste into notepad.

[Datum1]

The double line G74 must be use for OT controlls.. and for Fanuc 11 and later... the Single line G74 is used, but it will not retract above the face of the part....