g code for repeat the previous move - CNCzone.com-The Largest Machinist Community on the net!

woffler · #1 03-25-2008, 11:07 PM

i need to do some testing and iwould lke to write a siimple program say g1f3x.10 and then gif3x-.10 and repeat say 20 times . Ijust dont know how to do the repeat 20 times part .thanks

dcoupar · #2 03-25-2008, 11:50 PM

What kind of control are we talking here?

CNCRim · #3 03-26-2008, 02:59 AM

subprogram

Mitsui Seiki · #4 03-26-2008, 03:02 AM

Subprogram with L value.

cogsman1 · #5 03-26-2008, 06:56 AM

Main program OR MDI =
O1
M98P1111L20
M30

SUB Program =
O1111
G1X.10F3.
G1X-.10F3.
M99

Andre' B · #6 03-26-2008, 08:06 AM

Code:

#100=20
WHILE [#100GT0]DO1
G1X0.10F3
G1X-0.10
#100=#100-1
END1

woffler · #7 03-26-2008, 10:07 PM

i am using mach 3 and i would like to use the mdi if possible but main program is ok thanks everyone.i see from what has been posted that there must be some code some werethat i dont have . i have the regular g and m code listing where can i find what outhers used to come up with the code thank you again

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How Do I Repeat?	TZ250	Dolphin CADCAM	2	03-04-2008 05:11 AM
How to code a step motor axis move?	Niggo	OpenSource Software	3	08-13-2007 10:40 PM
Will Jog but not Move Correctly in G code	dafowfidy	Mach Software (ArtSoft software)	5	03-29-2007 10:27 PM
The X-Axles... to move or not to move!	Wild4aces	Mechanical Calculations/Engineering Design	1	03-18-2005 01:26 PM
Repeat g-code with y offset	tpaulson	G-Code Programing	19	11-29-2004 01:36 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)