G101 mirrir code - CNCzone.com-The Largest Machinist Community on the net!

eng_semsem1980 · #1 08-18-2007, 04:10 AM

good day
I want to make a mirror for my design but its not work can any body help me
I search about it and find G101 using to make mirror , but not work with me,I using mastercamx and cimco simulator

gar · #2 08-18-2007, 09:28 PM

070818-2124 EST USA

eng_semsem1980:

Download the HAAS mill manual 96-8000.pdf . In my copy the printed page numbers 143, 144, 145 discuss mirror image.

See if this helps.

Just write some very simple G-code by hand with which to experiment.

.

eng_semsem1980 · #3 08-19-2007, 02:22 AM

Thanks for your mail ,but I can't find ant attachment
can you send this file to my private mail OELHOSENY@YAHOO.COM

gar · #4 08-19-2007, 10:01 AM

070819-0943 EST USA

eng_semsem1980:

The HAAS site is www.HAASCNC.com
on the right side just below NEWS & COMMUNICATION is SITE MAP. Click on this.
Scroll down to customer service, then pick MANUAL UPDATES.
Next scroll down to OPERATOR MANUALS, then click on MILL 96-8000.

This takes you here
http://www.haascnc.com/customer_serv...mc/96-8000.pdf
This is about 13 megabytes.

.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
POST your success or failed story with G-REX G100 & G101	FPV_GTp	G-REX	19	10-19-2010 08:58 AM
G-code for beginners - want to learn G-code	FPV_GTp	G-Code Programing	7	11-17-2008 11:25 PM
Custom board for G-Rex G101	Matty Zee	Gecko Drives	6	04-29-2007 09:16 PM
looking for g code 3d from bobcadcam or simmilar for indexer lpt v5 with g code soft	troyswood	Ability Systems - LPT Indexer and G-Code	2	12-24-2006 09:21 PM
G200X, G101, G100 G-rex Help	stein	General Electronics Discussion	1	12-19-2005 03:38 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)