Cincinnati Hawk 150

[madmike46]

I am starting to work with a cincinnati Hawk 150. This is a used machine and we don't have all the manuals for it. I was wondering if anyone could help me locate manuals for this machine. I will also need help with the renishaw tool setter. Just wondering what tool offset page a person uses for tool setup,and for working offsets. This machine has an Acramatic A2100 controller.Can a person use the g code canned cycles for threading ,rough turning and boring like on the fanuc controllers? How does one set up for tool change positions? I have run this controller on a Cincinnati Arrow 750 Machining center but not on the turning centers. Any help will be greatly appreciated. I have been away from the trade for a few years so I'll need some help refreshing my memory. Thanks

[gwood]

--------------------------------------------------------------------------
For FREE Cincinnati Technical support you can call 1-800-934-0735
Listen to the prompt for Cincinnat; then for Tech support/Parts.
or... #4 wait for the ring to answer then #2 for Tech support/Parts.

Greetings from: Tech Support MAG Global Services
--------------------------------------------------------------------------

[madmike46]

Originally Posted by gwood -------------------------------------------------------------------------- For FREE Cincinnati Technical support you can call 1-800-934-0735 Listen to the prompt for Cincinnat; then for Tech support/Parts. or... #4 wait for the ring to answer then #2 for Tech support/Parts. Greetings from: Tech Support MAG Global Services --------------------------------------------------------------------------

Thanks for the info gwood. Looks like I will be the new owner of this machine in the new year. I have been running this machine part time for the last 3 years. It should have a few more good years of production left in it. Is there any way to tell how many hours this machine would have?

Thanks Again

Mike

[gwood]

Call in with the serial # off the back of the machine and we can tell you when the machine was ordered. There was never an hour meter in any of the Acramatic controls.