| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| G-Code Programing Discuss G-code programing and problems here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-24-2007, 08:32 AM
| |||
| |||
Recently purchased one of these from auction so no manuals, managed to figure out most things up to yet, but if anyone could tell me the correct syntax for calling/running subroutines, branch commands (like GOTO N{block number}, loops {do while, for next} and comparisons {if then else case etc.}, I would be most grateful.  |
|
#2
06-06-2007, 08:05 PM
| |||
| |||
| I have one of these controls on my Ciincinatti Sabre 750. Great control, love the touch screen. I have Gibbs Cam installed on the control, and used it for a couple of years, then purchased MasterCam and use it for all my programming now. I have all the manuals and could possibly copy the needed info for you if you still need it. Just exactly what are you trying to do? |
|
#3
06-07-2007, 01:15 PM
| |||
| |||
| Thanks for the reply, but I was lucky enough to get hold of a full set of manuals recently, so I'm all set now. Thanks again for the offer of help. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| acramatic 2100 questions | Clawsie Machine | General CNC (Mill and Lathe) Control Software (NC) | 7 | 07-07-2010 09:20 PM |
| acramatic 2100 crashed | machbuilder | Machine Problems, Solutions , Wireless DNC, serial port | 3 | 11-18-2006 11:38 AM |
| MasterCam V9.0 SP1 for Acramatic 2100 | Clawsie Machine | Post Processor Files | 5 | 09-03-2006 12:08 PM |
| Acramatic 2100 problem | mrfixit | Machine Problems, Solutions , Wireless DNC, serial port | 1 | 05-22-2006 08:28 AM |
| Acramatic 2100 Problems | Clawsie Machine | General CNC (Mill and Lathe) Control Software (NC) | 40 | 11-15-2005 07:38 AM |
| | |
Linear Mode
