help needed

[tomcook]

after 4 months
i have a machine ready to go it works by jogging
would like to make a part from a file
drew one in acad
converted it to g code
put it into mach 3 and ......
error
it said radius to end of arc differs from radius to start on line #260
what?????
heres the dfx drawing can someone check it out for me
please
cheers
tom

[lakeside]

This is the code from your dxf in bobcad
G00X0.Y0.Z0.1
X15.7697Y15.7854
G01Z-0.1F20.
G02X15.7597Y15.7754I-0.01J0.F10.
G01X9.8541
Y15.6179
G02Y14.8305I0.J-0.3937
G01Y14.673
X15.7597
Y14.8305
G02Y15.6179I0.J0.3937
G01Y15.7754
G02X15.7697Y15.7854I0.01J0.
G00Z0.1
from tool center
also not I used I,J no R

[tomcook]

thanks for the quick reply
however i do not know what that means
im a g code newbie sorry
i did a another test run and all it did was cut in circles
and did another one from the tutorials for sheetcam does exactly the same thine circles
it does not even resemble the part
whats going on??
maybe if someone posted a simple g code or point me in the right dirrection
just to see if it the code not the setup?
cheers
tom

[tomcook]

got it going after thinking why does it run in circle so had a quick look around in this forum i found that i had the machine state setup wrong

i made the machine cut the part
on the home run stretch BANG oh man the router craped out
supid bunning router
now have to wait till tomorrow
to get a new one
thanks for your help
cheers
tom