g71 canned cycle hitachi seike 10t-ef - CNCzone.com-The Largest Machinist Community on the net!

demenace · #1 03-12-2006, 12:17 AM

Hi all, Im using a Hitachi Seiki 25 M ATC and am trying to get the ,machine to do a canned cycle (g71) on a bore, basically to bore from 50mm to 170mm dia, i have done o/d canned cycles ok, but for some reason the I.D one has me flustered. Will this controller actually do ID canned cycles? thanks....

Ozemale6t9 · #2 03-12-2006, 04:03 AM

Hi,

I was going to answer this one myself, but I found it has already been answered here

The last paragraph, I believe, answers your problem.

regards, Oz

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)