DXF troubles - CNCzone.com-The Largest Machinist Community on the net!

kung · #1 11-02-2005, 11:09 AM

i have this dxf and i want to convert it to gcode but when i do it looks messy in nc plot. here is a link to the file here any tips on what im doing wrong??

ger21 · #2 11-02-2005, 11:38 AM

Try saving it as a version 12 or older .dxf

MetLHead · #3 11-02-2005, 03:41 PM

Kung,

I'm working on fixing up the DXF importer in NCPlot as we speak. However, I looked at your file and noticed that it's really a drawing of a 3d solid. NCPlot only really likes 2D drawings, so if you could, try to simplify the drawing as much as possible and save it as a v12 DXF.

Regards,
Scott

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)