Need Help!- 1/2-14 NPT Programming

[J.R. SWIGER]

Could anyone copy and paste an good example of code for the profile and threading for an external 1/2-14 NPT using the single line G76 cycle? Its for a Haas TL2, .031R turning tool, 60 DEG non-topping threading insert. I don't think the infeed angle (plunge/flank-cut) matters for the numbers I'm after but I could be wrong about that. Sorry if I look like a big dummy but I'm not confident of the numbers I come up with from the dimensions given in the machinist's handbook. Thanks Guys.

[g-codeguy]

This is for a Fanuc


X.88Z.3
G76X.7479Z-.8285K.0571D150I-.0347F.071429A50.

HTH

EDIT: Oops. Just noticed you also want the profile. This is an old sucker. Hope it is right. Okay, laid it out in MC to double check it.


N200M91 (ROUGH TURN THREAD 1/32R TOOL)
T0202S3000M3
X.9Z.005
G1X.2F.01
Z.02
G0X.85
G1Z-.1
U.02
Z.02F.015
X.6191
X.8289Z-.0849F.01
X.85Z-.4234
Z-.87
X.87
M92
M1

N400M91 (FINISH TURN THREAD 1/64R TOOL)
T0404S3000M3
X.7Z.02
G1Z0F.01
X.25F.003
Z.02F.015
G0X.63
G1X.6451Z.005
Z0F.002
G3X.6748Z-.0062R.021
G1X.8194Z-.0785F.003
X.84Z-.4088F.006
Z-.875F.003
X.86
M92
M1