Alright guys I had about 20min minutes today to get on the machine when the boss got out of my hair and went to a meeting.
My statement earlier about the X-axis moving is actually happening but when I ran the code it started and ended where it needed to be. The X-axis movement in-between I ass u me is a must to complete the arc??
Here is the code that I ran. Can anyone confirm that this is correct per the sketch?
This code starts at CL and dia of part at B0. Table rotates 9.2025 to first scallop which tucks the .5” endmill nice right in the corner .250” radius. G3 runs up to the top of the scallop then back down to the .250” radius.
Gotta run....kids are calling!! I will check back tonight from home.