Using K and R to make edge breaks

[hackmeister]

I'm using a Puma 280L with a Fanuc21i-TB contoller. I tried to put some radiuses, and chamfers on the part by using an R and a K in the program. The machine would do the radius , but not the K command to make a chamfer. I was trying to do this in a G71 turning cycle.
Does anyone know why it would not make the chamfer?
Thanks, Hacky

[dcoupar]

I found the following note on Multiple Repetitive Cycles in the Operator's Manual. It appears that Chamfering and Corner R can't be used in G70, G71, G72, or G73.

[hackmeister]

thank you dcoupar. I used to use the K and R edge breaks all the time on a fanuc 6T I used to operate. I never did try using them in a G71 cycle before. Now the weird thing is why did the 21i-TB do the R in the G71 cycle? I was trying to use both the K and the R in the same G71 cycle. maybe it will do one or the other but not both in the same G71 cycle.