HELP -- ACME .125 pitch with double start clipped

[Condor-mac]

I'm not sure on how to program this double start ACME .125 pitch that I asume is with a 8TPI insert, I'm guessing that the feed would be F.250 and each treading lead would have a different starting value (double)

first start at
Z.250
second start at
Z.500

the clipping would be the exact same programs but with a grooving tool at much lower RPM...

please anyone would help.
thanks

[sinha_nsit]

The second threading cycle should start at 0.375
The F-value in the threading cycle would be 0.250

[Geof]

......the clipping would be the exact same programs but with a grooving tool at much lower RPM...

please anyone would help.
thanks

Not quite 'exact same' you want the grooving tool offset half a pitch and it pulls out at the beginning not at the end.