Hey all,
Seem to be having a little hang up on getting some live action turning to do some dogs on the face(s) of my part. It's 2-.15 wide dogs, 180 degrees apart on a 1.25 OD part. I did attempt to convert the milling program we used to use for this part, but the PUMA240 MSB we use wasn't having any of that nonsense(double my Y's and change to C)...Such a stupid struggle for something that should be so simple.
Any and all help is appreciated!
Similar Threads:
G03X4.342C-.3491I2.1575J-.07F64.0000
G03X4.722C-.1398I2.1613J-.1494F64.0000
G01X3.9122C-.1872Z.185F64.0000
G03X4.3076C-.3895I2.1561J-.1895F64.0000
G03X4.3076C-.3895I2.1575J-.07F64.0000
G03X4.7122C-.1918I2.1561J-.1895F64.0000
G01X3.8936C-.2151Z.185F31.
G03X4.2646C-.4286I2.1463J-.2291
G03X4.2646C-.4286I2.1575J-.07
G03X4.6916C-.2431I2.1463J-.2291
G01X4.6916C-.2431Z.7F600.0000
This is the converted-x's have been doubled from original, and y's to c's...
I know that it isn't happy because it can't read the J values...but i am at a loss as to what a "J" would be converted to?
This is a new approach i took to this, but I keep getting a "G112 not allowed" alarm? I don't know why this is creating such a headache...ugh...
O1611(TEST)
N5
T1000(.5 ENDMILL)
G54G98
M35
G0G28H0
G50C0
G97M34S5000
G0G54Z.1T1010M08
X1.5
G112
G1G98Z.9F50.
X1.25F10.
G2X1.225C-.075R.025
G1X1.125C-.075
G2X-1.125C-.075R.6125
G1X-1.225C-.075
G2X-1.25C0R.025
G2X-1.25C.075R.025
G1X-1.125C.075
G2X1.125C.075R.6125
G1X1.225C.075
G2X1.25C0R.025
G0X2.
G97S500
G113
G0G28H0
G0Z.1M09
X6.Z2.
M35
G99
G28U0
G4X3.
M01