Results 1 to 4 of 4

Thread: Not getting email alerts for updated threads

  1. #1
    Wanna be
    Join Date
    Mar 2004
    Location
    United States
    Posts
    551
    Downloads
    0
    Uploads
    0

    Not getting email alerts for updated threads

    I am not getting email updates (alerts) for new posts to threads that I have subscribed to. Is there anyone who may be able to look at this for me?

    Thank you.

    Dan
    Check out what I am working on at www.routerbitz.com!


  2. #2
    Site Owner CNCadmin's Avatar
    Join Date
    Mar 2003
    Location
    United States
    Posts
    6,947
    Downloads
    2
    Uploads
    3
    Did you check your setting under "usercp"? Than check your spam filter.
    Thank You,
    Paul G
    Site Owner-Webmaster-
    Administrator
    www.rfqwork.com
    www.cnczone.com
    www.welderzone.com


  3. #3
    Wanna be
    Join Date
    Mar 2004
    Location
    United States
    Posts
    551
    Downloads
    0
    Uploads
    0

    Didn't find anything

    Checked your suggestions and did not find anything that would make it obvious to me that it was a user setting. I did reset some of the notifications to "daily" instead of "instant". I highly doubt this will do any good, but I can hope. Any other suggestiions?

    Thank you for your help.

    Dan
    Check out what I am working on at www.routerbitz.com!


  4. #4
    Site Owner CNCadmin's Avatar
    Join Date
    Mar 2003
    Location
    United States
    Posts
    6,947
    Downloads
    2
    Uploads
    3
    Thank You,
    Paul G
    Site Owner-Webmaster-
    Administrator
    www.rfqwork.com
    www.cnczone.com
    www.welderzone.com


Similar Threads

  1. Updated Vac Shoe
    By IQChallenged in forum CNC Wood Router Project Log
    Replies: 0
    Last Post: 10-24-2009, 07:32 PM
  2. Problem- Two OM-s, different behaviour [UPDATED]
    By padobranac in forum Fanuc
    Replies: 7
    Last Post: 09-20-2008, 07:40 AM
  3. MiniDRIVEDC+ updated
    By Vider in forum Servo Motors and Drives
    Replies: 0
    Last Post: 06-15-2005, 04:58 AM
  4. Saving threads or parts of threads???
    By flybynight in forum Forum Questions or Problems
    Replies: 4
    Last Post: 02-22-2004, 01:19 AM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.