Results 1 to 1 of 1

Thread: Jerky Matsuura Mill

  1. 09-15-2008, 08:32 PM #1
    Tony(BDE)
    Tony(BDE) is offline
    Registered
    Join Date
    Sep 2008
    Location
    usa
    Posts
    7
    Downloads
    0
    Uploads
    0

    Jerky Matsuura Mill

    Hi, I am Using ONECNC Software for programing on my Matsuura Mill, and I Am drip feeding from a lap top for LARGE Programs. My Question is how can I get the laptop to send the program, so that the machine dose not jerk around so much, I know the lap top sends the code faster then the Matsuura can accapt it. Are there any parameters I can change on the Matsurra mill?
    Thanks
    Tony(BDE)
    Last edited by Tony(BDE); 09-15-2008 at 10:52 PM.

« Waiting for eternity | post a new question? »

Similar Threads

  1. Matsuura Mill setup question- basic (probably same as Fanuc etc)
    By Robmatsuura in forum General CNC (Mill and Lathe) Control Software (NC)
    Replies: 9
    Last Post: 09-04-2012, 06:43 PM
  2. Need Help!- jerky movement
    By Claude Boudreau in forum BobCad-Cam
    Replies: 10
    Last Post: 03-08-2012, 07:22 AM
  3. Jerky motion
    By Matty Zee in forum G-REX
    Replies: 9
    Last Post: 03-28-2010, 03:35 AM
  4. Jerky CNC Motion
    By Cartierusm in forum DIY CNC Router Table Machines
    Replies: 29
    Last Post: 03-30-2009, 07:48 PM
  5. Matsuura Mill setup question
    By Robmatsuura in forum General Metal Working Machines
    Replies: 0
    Last Post: 10-25-2007, 10:40 AM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.