| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Forum Questions or Problems Post any questions about how to use the forum or any bugs/problems you may be having in this forum. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
10-06-2004, 12:45 PM
| |||
| |||
Just as I hit a link I realized that the ad that was on the page I left might be interesting, it was gone. I used "Back" in the browser, but of course then there was a new one. Is there a collection of those random-ads where I can find it. I know there used to be a list of advertizers, but I'm not able to find it again.  |
|
#2
10-06-2004, 03:53 PM
| ||||
| ||||
| Yes their use to be a list but I had to have it re-done by my programmer to work with the new site's software. I will have a advertisers list very soon and all the banners and links to their site will be found there.
__________________ Thank You, Paul G Site Owner-Webmaster- Administrator www.rfqwork.com www.cnczone.com www.welderzone.com |
|
#4
10-12-2004, 11:57 AM
| ||||
| ||||
| F5 F5 F5 F5 It should show up eventually.. 
__________________ Matt San Diego, Ca ___ o o o_ [l_,[_____], l---L - □lllllll□- ( )_) ( )_)--)_) (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#6
10-12-2004, 01:30 PM
| ||||
| ||||
I bet the Missus is estatic... 
__________________ Matt San Diego, Ca ___ o o o_ [l_,[_____], l---L - □lllllll□- ( )_) ( )_)--)_) (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#11
02-11-2005, 12:09 PM
| ||||
| ||||
| OK here is a temporary list of advertisers http://www.cnczone.com/forums/advertiserlist.php their maybe a few missing.
__________________ Thank You, Paul G Site Owner-Webmaster- Administrator www.rfqwork.com www.cnczone.com www.welderzone.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How do you hook up limit and home switches? | CNCadmin | DeskCNC Controller Board | 6 | 09-23-2007 03:34 PM |
| desknc for dos home switches | gearcut | Carken Products (Deskam, DeskCNC etc) | 0 | 05-24-2005 11:29 PM |
| mach2 home switches | kong | Mach Software (ArtSoft software) | 14 | 11-27-2004 08:09 AM |
| The relationship of limit switches to home switches. | MikeAber | General Electronics Discussion | 4 | 11-04-2004 01:28 PM |
| Limit switches and home switches | viktorcnc | TurboCNC | 2 | 08-03-2004 06:11 AM |
| | |
Linear Mode
