PM problem - CNCzone.com-The Largest Machinist Community on the net!

ger21 · #1 08-14-2004, 10:01 AM

Paul, I start the site at the main forum page, and got a message that I had a PM. I opened it in a new window, and deleted it after i read and replied to it. I then went int a forum, and when I came back to the main forum, I got the message again that I had a new PM. When I opened it in a new window, there was an error, because it was the same PM i just deleted, which was no longer there. I then went into another forum, and when going back to the main forum page, I got the message again that I had a new PM.

CNCadmin · #2 08-14-2004, 10:02 AM

I will look into it, as I have not seen that happen on my end.

ger21 · #3 08-14-2004, 10:26 AM

It did it again after I posted the above, then seemed to stop

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Okuma LC-20 Threading problem	Gunner	Machine Problems, Solutions , Wireless DNC, serial port	13	12-13-2011 10:11 PM
Beginner Troubleshooting and Building Considerations	coherent	FAQ of CNC Machine building	3	11-10-2011 01:27 PM
Inverter noise problem Help !!!	mbam	Phase Converters and VFD	17	06-06-2005 05:24 PM
CNC gantry Machine shows problem	Alex S.A	Machine Problems, Solutions , Wireless DNC, serial port	15	04-25-2005 03:02 PM
Fadal VMC4020A axis problem	cwww	Machine Problems, Solutions , Wireless DNC, serial port	16	12-01-2003 11:07 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)