deleting post

[cabnet636]

as i know it and i stand ready to be corrected jim mcgrew www.mcgrewwoodwork.com aka CABNET

a thread was started on 11-09-07 by "rocket" and as i have come to understand from austrailia

he was very excited about the purchase of his excitech router after researching on other threads on the cnc zone forum.

he was soon joined by bclark myself and kustom koncepts.

another poster named "carvin marvin" joined in and posted seven times over the next few days "carvin was PM ing (private messages) others on the thread about his alledged experience with the "chinese router"
at the request of the moderator "carvin" posted (post #66) that the machine was made with plastic gears and was rusty he offered to post photos of his machine and to date he has not done that in fact i believe by my research has not posted any were on the cnc zone since. he joined on 11-15-07 and posted untill 11-21-07 a research on him on the member list will confirm this.

the messaging somewhat accused rocket of being a sales agent for the shcnc or excitech router and as researsh will now show rocket is not a sales agent, he is a small businessman in australia making closet cabinetry and such. rocket removed some of his early post after carvins posting.

i now understand the cnc admin has restored rockets ability to post on the forum, and i am gratefull

i would like to post this so we may all continue to learn how to use this forum

since my coming on board with rocket and all of you i have bought a 4x8 www.camaster.com machine of which i am very proud. i absolutly could not have done this with out the axcess to this forum and the shared learning experience of all of you. i dont know if there is any method of warning and resolution for removing someone from the forum.
but i would urge all to read up on policys and procedures for participating in the cnc zone

i would like to say we are fortunate here, some forums are very strict as to what is discussed as advertising dollors dominate in some since censorship.

jim mcgrew

[cabnet636]

would it be ok to post this on the excitech thread

i would like to remind everyone to read the policy's and procedures jim

[ger21]

would it be ok to post this on the excitech thread

No, he's already posted in that thread not to discuss it there. There's really nothing to discuss. Matter has been resolved, case closed.