Results 1 to 3 of 3

Thread: Posting problem

  1. #1
    Registered
    Join Date
    Nov 2006
    Location
    Scotland
    Posts
    917
    Downloads
    0
    Uploads
    0

    Posting problem

    I find the zone loads a lot quicker now,is not jittery and does not hang up.I have done nothing to my computer so your upgrades must have cured the problem.
    The new problem is,if I come to the forum through a link in my email to a thread to which I have posted and someone has replied the following happens.If I type a reply and send it I get the message "thank you for posting you will now be returned to ......"
    If at this stage I try to close the page to go back to my email the screen starts jumping and IE loads about 50-60 times.That is the blue box on the start line at the bottom of the screen will show IE and the number and it will keep increasing.This has happened three times tonight and a couple of times last week.The only way out is to hold the power button in and shut down.Any suggestions apart from patience?
    Mark.


  2. #2
    Community Moderator ger21's Avatar
    Join Date
    Mar 2003
    Location
    Shelby Twp, MI....USA
    Posts
    22,303
    Downloads
    0
    Uploads
    0
    Use Firefox instead of IE.
    Gerry

    Mach3 2010 Screenset
    http://home.comcast.net/~cncwoodworker/2010.html

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)


  3. #3
    Registered neilw20's Avatar
    Join Date
    Jun 2007
    Location
    Australia
    Posts
    3,424
    Downloads
    0
    Uploads
    0

    Talking Hear Hear!

    IE sucks.
    Super X3. 3600rpm. Sheridan 6"x24" Lathe + more. Three ways to fix things: The right way, the other way, and maybe your way, which is possibly a faster wrong way.


Similar Threads

  1. Problem posting G-code.
    By josh_75964 in forum LazyCam
    Replies: 2
    Last Post: 09-12-2007, 03:14 PM
  2. CAM Software Problem not Posting <--Fix
    By DiscountFinds in forum General CNC (Mill and Lathe) Control Software (NC)
    Replies: 0
    Last Post: 04-05-2007, 10:25 AM
  3. Posting problem
    By RotaryNut in forum Forum Questions or Problems
    Replies: 4
    Last Post: 02-11-2007, 11:19 AM
  4. Mastercam posting problem
    By Redd in forum Mastercam
    Replies: 2
    Last Post: 02-08-2007, 02:24 PM
  5. Problem posting pictures
    By mccafferty in forum Forum Questions or Problems
    Replies: 1
    Last Post: 07-15-2004, 10:53 AM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.