Results 1 to 3 of 3

Thread: thread subscription problems

  1. #1
    Registered massajamesb's Avatar
    Join Date
    Mar 2006
    Location
    usa
    Posts
    759
    Downloads
    0
    Uploads
    0

    thread subscription problems

    Is anyone else having thread subscription issues?
    Here lately I have not gotten any notification of PM's from other members, or subscribed thread notifications. I have gone through the User CP section, all the settings are correct, and I have gone through my Yahoo email account, all is working correctly there as well.
    I am puzzled
    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)

    "If the women don't find you handsome, they should at least find you handy"
    -RedGreen show.


  2. #2
    Site Owner CNCadmin's Avatar
    Join Date
    Mar 2003
    Location
    United States
    Posts
    6,947
    Downloads
    2
    Uploads
    3
    If you are using a toolbar, your toolbar is block the pop-up message that you have a new PM, as for emails, your email service is blocking them.
    Thank You,
    Paul G
    Site Owner-Webmaster-
    Administrator
    www.rfqwork.com
    www.cnczone.com
    www.welderzone.com


  3. #3
    Registered massajamesb's Avatar
    Join Date
    Mar 2006
    Location
    usa
    Posts
    759
    Downloads
    0
    Uploads
    0
    Thanks Paul, I went through my email, and found that Yahoops had marked your email address as bulk/spam, so any emails you have sent me, or any from this site have been lost
    It is odd, because it seemed that I was getting less and less notifications over the last couple weeks, slowly tapering off to nothing.
    Stupid Yahoo account. They also had a few of my close personal friends listed as bulk mail
    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)

    "If the women don't find you handsome, they should at least find you handy"
    -RedGreen show.


Similar Threads

  1. Thread milling problems and questions.
    By magneto259 in forum G-Code Programing
    Replies: 63
    Last Post: 05-08-2007, 10:25 PM
  2. hey. where did my thread go
    By fastimes in forum General Waterjet
    Replies: 7
    Last Post: 08-26-2006, 12:15 PM
  3. GHT thread
    By Flyinfool in forum General Metalwork Discussion
    Replies: 5
    Last Post: 07-12-2005, 03:49 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.