I have no idea, have look at the site on 4 different computer and have not had any problems. I have not done any hacking to the site in about a week.
Paul, in the last day or two, I think it only happens in the first thread I look at, the page will load (at least partially, and an error message pops up:
"Internet Explorer can not open ....(the url)
Operation Aborted"
Then the typical IE page when a page is not found.
After the one time, it seems to work fine. This has happened on 2 different computers.
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I have no idea, have look at the site on 4 different computer and have not had any problems. I have not done any hacking to the site in about a week.
Thank You,
Paul G
Site Owner-Webmaster-
Administrator
www.rfqwork.com
www.cnczone.com
www.welderzone.com
I have been having the same problem for the past few days also.
The cure for all:
http://www.mozilla.org/products/firefox/
Jon
disable your error reporting in the IE options advanced tab.
Thank You,
Paul G
Site Owner-Webmaster-
Administrator
www.rfqwork.com
www.cnczone.com
www.welderzone.com