posts are newest to oldest ?
When I open a thread it shows the most recent post first .I realize this makes more sense , but is there a setting to make it go old school , where you see OP's first post on the first page , and the recent posts are on the last page ?
I'm mentally challenged, and this confuses me
Similar Threads:
I don't actually know anything about CNC router tables , but I stayed at a Holiday Inn Express last night
Re: posts are newest to oldest ?
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Re: posts are newest to oldest ?
From what I'm used to . My first post is at the bottom of this thread now . Just unusual to me is allOriginally Posted by ger21
I don't actually know anything about CNC router tables , but I stayed at a Holiday Inn Express last night
Re: posts are newest to oldest ?
That was a link to show you how to change it....
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Re: posts are newest to oldest ?
My bad . Thank you very much !
I don't actually know anything about CNC router tables , but I stayed at a Holiday Inn Express last night
Reply with Quote
