Usually just one I think, and it took 10 minutes.
You waited 12 years to post?
Folks,
I've been a member for a while but have never posted.
When I post, a see that my post needs to be approved before it becomes visible. Being a moderator on a completely different site, I understand the approval process. My questions how many posts do I need so that the approval process is no longer required? Also, how long does approval usually take?
Thanks,
Newbie Arjay
Similar Threads:
Usually just one I think, and it took 10 minutes.
You waited 12 years to post?
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks. 12 years? Wow. I don't like to rush into anything.
I posted yesterday in the kflops controller forum (and got the mod approval msg), got it again today so that's why I contacted you.
Anyway, thanks for getting back to me. I'll go check that I can see the posts.
Arjay
For me, I approve posts as soon as I see them.
Most moderated posts are new threads, and are easy to spot. Because your post was a reply, It wasn't easily noticeable. Sorry about the delay, but your all set now.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
got one in que for approval.