... and a chip load spread sheet...
Cool site, how about a place post machining charts for quick ref. just a thought... ex: thread %, c'sink dia for thread holes, three wire cal.....
Thanks keep up the good work
Similar Threads:
... and a chip load spread sheet...
We have an FTP site, as well as a tech articals section that you could use for that. You could also start a thread in Machining Processes and Solutions and start posting stuff there. I'm sure a lot of peeps will add to it.Originally posted by tpdolph
Cool site, how about a place post machining charts for quick ref. just a thought... ex: thread %, c'sink dia for thread holes, three wire cal.....
Thanks keep up the good work
'Rekd
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
p.s.,
YUK!three wire cal.....
'Rekd
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)