Help! - MM2001 & GMFC motor movement - CNCzone.com-The Largest Machinist Community on the net!

DreamerM · #1 05-31-2007, 06:01 PM

Hi

Today I finished building my CNC hotwire foam cutter. I am using MM2001 & GFMC. When I move the motor "manualy" (in the menu bar) GMFC >> Zero Axis... it works fine but when i try to cut the motors stand still.
I also tried to work with Jedicut and move the motors via the hidden right menu, i got the same results the motors doesn't move when i try to CUT.
PLZ help

Regards
Maayan

MITECH · #2 10-09-2008, 11:06 AM

YOUR STEPS PER REVOLUTION MUST BE CORRECT ACCORDING TO YOUR STEPPER MOTORS IE: DEGREES PER STEP AND YOUR MM PER REVOLUTION MUST BE CORRECT FOR YOUR SCREW THREAD ON YOUR X/Y AXIS THREADED BARS.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help on programing the PIC in MM2001	DreamerM	PIC Programing / Design	2	08-29-2011 08:56 PM
GMFC help needed	gguidi	CNC Wire Foam Cutter Machines	4	07-25-2007 08:03 PM
Help on programing the PIC in MM2001	DreamerM	CNC Wire Foam Cutter Machines	3	06-01-2007 05:15 AM
MM2001 v0.62	JerryFlyGuy	CNC Wire Foam Cutter Machines	1	12-06-2005 08:18 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)