| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| FlashCut CNC Discuss FlashCut CNC software here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
05-18-2007, 10:35 AM
| ||||
| ||||
| Feed per rev & constant surface feed , is possible if the spindle shaft has an encoder, which it should if it also has normal threading operations G96 = CSF, G94 = Feed/Min, G95 = feed/Rev. Just noticed this is the FlashCut forum, I don't know wether these apply to this system. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| lathe + power feed + measure + z | deji | General Metalwork Discussion | 3 | 05-15-2007 11:26 AM |
| Lathe work feed back | Kool Parts | Machinist Feedback | 0 | 09-27-2006 09:30 AM |
| Where's the Lathe Speed, Feed, and Depth Data?? | Otokoyama | General Metal Working Machines | 4 | 02-06-2006 02:14 PM |
| different torque modes | posix | Open Source Controller Boards | 0 | 06-11-2005 08:10 AM |
| Use both I & K and R modes in G2 and G3 | Karl_T | CamSoft Products | 5 | 04-15-2005 08:00 PM |
| | |
Linear Mode
