THe reason I raised the question here is:
-Max Pulse rate
I have contacted Flashcut they tell me the max. pulse rate is 30khz per second, I wonder what is the practical max. pulse rate at this level the control the motion is stable and smoothly? it is very important to the resolution of machine.
i.e. if 0.005mm/microstep and 30KHz pulse rate, the max. speed is 150mm/s i.e 9000mm/min.
-The above max. speed is 3D contuoring speed? if yes, how about 2D speed?
-How about rapid traverse speed?
-Any one use the function of rack ATC, is it possible to change to rotary ATC with 8 tools?
-If using the controller to drive dual X axises, is it possible to use macro to check the position of each axis with promisity sensor?
-As for the handdeld kepad, it is seems too expensive and not up to industry standard
such as withour ESTOP and dust protected. is it possible to made by our own.
-how about the quality of the signal generator.
-Othe pratical using experience and advice for this controller.
I hope can hear from you. Thak you very much.