Nathan,
Have overcome the issues explained in my email to you last night and a couple more with my own solutions. However, the 4 motors in my kit have 3/8" drive shafts but I received hardware for 1/4" shafts. Machine looks impressive thus far but suggest some updating of instructions, either video or paper enclosure, to explain changes due to parts design changes and/or outsourced supplier changes. Nothing that most can't overcome but would save some assembly thus re-assembly
frustrations.
Would rather have reported this via email or by phone but as said by someone else on the forum, you can be slippery
Tom
Similar Threads:
Fine Line Automation
www.finelineautomation.com
I had good communication with Nathan last night and he is resolving mis-match parts issue to my satisfaction.
Tom