POST for FANUC 15T - CNCzone.com-The Largest Machinist Community on the net!

bmlw · #1 01-06-2008, 01:55 PM

Does anyone have a POST for Featurecam/turn for A FANUC 15T controller? Or can you tell me what needs to be changed in the FANUC 10 POST to make it compatible with the 15T?

rick_7037 · #2 01-14-2008, 11:31 AM

I use this one on My Hitachi 15M

bmlw · #3 01-14-2008, 05:53 PM

Thanks for the file I will take a look at it asap.

rick_7037 · #4 01-14-2008, 08:18 PM

jeeeesh brain fart I just sent you a mill post....
should be a fanuc 11T that comes out of the box that should work fine on a 15T
the 6T should also work ok If you have to make any changes to G-Code let me know what they are and I will fix them in a post for you sorry about my confusion!

bmlw · #5 01-14-2008, 09:04 PM

I will try to get to it soon but I am off to work for the next 45 to 60 days and I need to take care of the honey doos.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Post for Fanuc 10T	geezr	Post Processor Files	0	08-28-2007 05:07 PM
Need post UG NX post for Fanuc Robodrill with Fanuc Series 16i-MB	shj066	Post Processor Files	2	07-12-2007 02:59 PM
Need post Delcam PowerMILL post for Hardinge VMC 600 II with Fanuc Series oi-MB	littlem	Post Processor Files	0	10-26-2006 05:59 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)