FeatureCAM question, corner rounding

[rkdygert]

I'm running FeatureCAM 2006 and am having trouble figuring out how to make it mill a part with sharp corners. No matter what I do, it always seems to round the corners slightly. I've been reading the documentation and it seems to have something to do with feedrate optimization, but I can't figure out how to disable it. Any suggestions?

Thanks,
Ryan

[duluthboat]

I can do it but I can’t tell you how. ;-) Lets see, manufacturing, machine attributes, misc, on this page you should be able to turn on and off, corner rounding. I don’t have access to the software here so I’m using a shaky memory.

Gary