Help plzzz

[hanho]

Hello everyone,

Would anyone show me how to program the other side of stock. I program a pocket on one side, now I'd like to program the same pocket but the other side. Please help me. Thanks alot.
Oh, and show me step by step please 'cause i am student.

[awemawson]

If you set your pocket Z start height lower than the top of the stock, and the depth so it matches the bottom of the stock you will have your pocket.

You won't be able to machine it on a test run though without flipping the stock

AWEM

[hanho]

Thanks, any other ideas?? please post up. Thanks

[dmealer]

Make a new set up on the back side of your stock.Then program the new pocket under the new setup. This method will even flip the verification, so that you have a realistic part on your screen. Don't forget to rotate the new set up 180° so that the Z axis is orintated the proper direction.

[hanho]

I did, but somehow i could not get it right. I created new UCS, then rotate 180. After that I translate by pick point but still could not be right. Anyone can show me step by step i would apreciate it, thanks and have nice day.