Need a decent post for a Haas SL30 (turning)? - CNCzone.com-The Largest Machinist Community on the net!

omnitech · #1 10-13-2011, 11:39 AM

I recently acquired the add-on for turning for Featurecam. The post for a Haas SL30 is horrible. It basically renders canned cycles useless and comp issues out the tail. The whole post is structured horribly. Anyone have something decent they've put together? Thanks ahead.

vf1kf · #2 10-13-2011, 03:22 PM

I have a post I dialed in for my SL20...you're welcome to try it out. Let me know if it works for you.

omnitech · #3 10-14-2011, 06:27 AM

Originally Posted by vf1kf

I have a post I dialed in for my SL20...you're welcome to try it out. Let me know if it works for you.

Thanks for the response and post, looks like you have the comp issues dialed in, but it only has a M3 to turn the spindle on. There's no G96 or G97 code. I didn't even think you could turn a spindle on with just a M3? And I'm a little lost on the u and w code? I've never seen them used?

Muzzy · #4 10-14-2011, 09:19 PM

I have sent you a PM

Jansip · #5 10-28-2011, 09:48 PM

I need to post to ST30 turn / mill

Thaks Jansip

Muzzy · #6 10-29-2011, 08:32 AM

I'm working on it for you will let you know if I have one

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wanted Haas SL30	CGreye	Want To Buy...Need help!	1	08-18-2010 04:43 PM
Need Help!- Haas SL30 alarm K#-965	mgcmn	Haas Lathes	0	07-18-2010 09:15 AM
Need Help!- help whit post processor for haas sl30 in sprit 2007	HAASESTUDENT	Esprit	0	04-20-2009 05:42 PM
Help with G76 on Haas SL30	quadtard	Haas Lathes	4	08-07-2008 05:59 PM
Need Edgecam Post for Haas SL30	1ctoolfool	EdgeCam	0	10-17-2007 12:00 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)