Problem How do you change the nc post from radial to diametric - CNCzone.com-The Largest Machinist Community on the net!

rdb4420 · #1 07-21-2011, 10:14 AM

all my machines i run are using diametric input for their programs however my featurecam is posting in radial and i need to change that and have no idea how, so if anyone could help and tell me what i need to change it would be much appreciated

Janos · #2 07-21-2011, 07:19 PM

What kind of machines do you have. I might have a post from where I used to work that you could tweak.

Janos · #3 07-22-2011, 07:54 PM

Nevermind my last post! It is MUCH easier than editing a post. If you go to the top of the page in the options tab, go down to the turning input mode, select the diametric input and TADAA!!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Small post change	Mark and Poco	Post Processors for MC	1	02-02-2011 10:09 AM
please show me how to change the post x3	concoo	Post Processor Files	0	01-16-2010 04:03 PM
how to change a dmu 50evo to a dmu 70 post	broon	Post Processors for MC	1	05-28-2009 07:21 AM
Change M- code in post?	Stebedeff	Mastercam	5	10-06-2008 09:51 PM
Help with post change	proform	Post Processors for MC	2	11-06-2006 09:16 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)