Featurecam not supporting 32bitOS - CNCzone.com-The Largest Machinist Community on the net!

Protoconcept · #1 05-19-2011, 08:27 PM

Hey guys, its been a while since I've been in the biz, but I used to use featurecam a few years ago. Was looking into it again cause I'm thinking about buying another machine, however I get the impression that featurecam after 2010 is not supporting any 32 bit os's? Is that true?

I have good pc with xp-64 so its not soo bad, but my laptop is only 32 bit, so kinda just working out what i need to get, cause working on the laptop is so much more practical for me.
Cheers guy.
ProtC

andywarwick · #2 05-20-2011, 09:52 AM

It's still currently fully supported in both 32-bit and 64-bit versions as far as I know

andywarwick · #3 05-21-2011, 05:53 AM

Featurecam is still fully supporting 32 bit and will continue to do so, obviously at some point it will cease support for 32 bit (as will all software manufacturers!) but at the moment there is no planned date for the support to end

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mastercam not supporting V9.	TheBigJW	Post Processor Files	2	08-31-2010 07:54 AM
Need an example of GibbsCAM post processor supporting Tombstone Management System	Captain_Nemo	Post Processor Files	0	01-16-2008 03:42 PM
PC based CNC supporting closed loop at the CNC	VNR	General CNC (Mill and Lathe) Control Software (NC)	12	05-15-2006 01:15 PM
static supporting shafts, y?	max_imum2000	Linear and Rotary Motion	3	01-18-2006 01:28 PM
software supporting RS232 and RJ-45	max_imum2000	CamSoft Products	1	01-11-2006 03:00 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)