Need Help!- FeatureCam Lathe Issues

[CHampshire]

Hello all. I am having issues with featurecam posting out the code for g71 and g70 roughing and finish cycles. The machine is a fanuc 21i control. When I am either boring or turning, it doesn't want to insert cutter comp in the path for the roughing cycle. Therefore when it goes to do the finishing with either the same or a different tool, it generates a new path and calls up those line numbers. Examples as follows:

This is an example of how I want the code to read:
N20T909
N25M8
N30G96S600
N35G0X-0.2Z0.115M13
N40G71U0.035R0.025
N45G71P50Q95U-0.01W0.005F0.01
N50G41G1X1.715F0.01
N55Z0.
N60G2X1.675Z-0.02R0.02
N65G1Z-0.0799
N70X1.1513Z-0.1752
N75G2X1.125Z-0.194R0.02
N80G1Z-1.875
N85Z-1.89
N90G40X0.925
N95G0X-0.2
N100G0Z0.115
N105G96S650
N110G70P50Q95
N115G0X10.0Z10.0
N120M30
%

Here is a screen shot of what I get when I post. I have tried a couple different fanuc posts but still have the same issues. Since it re-gens the code so to speak and the path is after the canned cycle call, it runs the finish twice. I'm pretty frusturated and dont want to have to edit the nc code in the future either. Any help is greatly apprecicated. Thanks!



I noticed the code might be a little small to read so am posting it as well.
%
:
(1875RISER)
(3-12-2011)
(T9=375X250)
N40T909
N45G50S2400
N50G96S600
N55X-.2Z.01M13
N60G71U.035R.025
N65G71P70Q100U-.01W.005F.008
N70G1X1.745F.008
N75Z0
N80G2X1.675Z-0.035R0.035
N85G1Z-.0844
N90X1.1711Z-0.1761
N95G2X1.125Z-0.209R0.035
N100G1Z-1.89
N105G0X-0.2
N110G0X1.9082Z0.0259T909M8
N115G96S650
N120G70P125Q160
N125G41G1X1.715Z0F.006
N130G2X1.675Z-0.02R.02
N135G1Z-0.0799
N140X1.1513Z-0.1752
N145G2X1.125Z-0.194R.02
N150G1Z-1.875
N155Z-1.89
N160G40X.925
N165G0X0.865Z0.0259
N170Z0.1
N175X5Z5M9
N180M30
%