Need Help! Should be easy - CNCzone.com-The Largest Machinist Community on the net!

vebers · #1 06-11-2010, 10:23 AM

Hey this should be a no brainer but I am here as the result of hours looking, evidently in all the wrong places. I need to change X direction output when the code posts. It always gives me X- AAAA and I need it X AAAA. This is the turning product.

Thanks

Machsol · #2 06-17-2010, 10:37 AM

Look at your set up axis. You should be able to go in and rotate the part around Z to have X facing the other way. Then re-post the code. Should do it.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
this is not easy	cob	Mastercam	9	02-10-2009 08:15 PM
MastercamX not so easy with easy projects	X7racer	Mastercam	7	05-21-2008 09:28 PM
How easy is it?	SPD	Employment Opportunity	26	03-03-2007 01:50 AM
Easy CNC and Easy Stepp'n	kylecroft	CNCzone Club House	5	02-18-2007 11:54 AM
Pro Nc And Easy Dnc	SMACUSTOMS	General CNC (Mill and Lathe) Control Software (NC)	0	05-07-2006 05:08 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)