Flashcut to replace Bandit control on Older Cnc mill

[anoramose2007]

Looking at replacing my Bandit control on a SHIZUOKA CNC mill.This mill is used part time in my garage.Any one using Flashcut ?I'd like your opinion on software and support.I've talked to Flashcut saleperson a few times.They didn't have a any one to talk to in Twin cities(MN)area that has retrofitted with Flashcut Cnc .

Thanks

[Pure-Powder]

Looking at replacing my Bandit control on a SHIZUOKA CNC mill.This mill is used part time in my garage.Any one using Flashcut ?I'd like your opinion on software and support.I've talked to Flashcut saleperson a few times.They didn't have a any one to talk to in Twin cities(MN)area that has retrofitted with Flashcut Cnc .

Thanks

This is the FASTCUT CNC Forum , you would have better luck posting in flashcut milling section....

Thanks