Flashcut to replace Bandit control on Older Cnc mill - CNCzone.com-The Largest Machinist Community on the net!

anoramose2007 · #1 12-27-2010, 06:41 PM

Looking at replacing my Bandit control on a SHIZUOKA CNC mill.This mill is used part time in my garage.Any one using Flashcut ?I'd like your opinion on software and support.I've talked to Flashcut saleperson a few times.They didn't have a any one to talk to in Twin cities(MN)area that has retrofitted with Flashcut Cnc .

Thanks

Pure-Powder · #2 12-27-2010, 08:32 PM

Originally Posted by anoramose2007

Looking at replacing my Bandit control on a SHIZUOKA CNC mill.This mill is used part time in my garage.Any one using Flashcut ?I'd like your opinion on software and support.I've talked to Flashcut saleperson a few times.They didn't have a any one to talk to in Twin cities(MN)area that has retrofitted with Flashcut Cnc .

Thanks

This is the FASTCUT CNC Forum , you would have better luck posting in flashcut milling section....

Thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bandit Control	DieGuy	General CNC (Mill and Lathe) Control Software (NC)	1	02-05-2011 08:17 PM
Retro-fitting Shizuoka mill with old Bandit control	anoramose2007	Knee Vertical Mills	0	12-26-2010 10:54 AM
Newbie- Older Bridgeport splindle motor replace	ddeaton	Bridgeport and Hardinge Mills	10	03-12-2008 12:59 PM
Using Flashcut CNC Spindle rotate card control to control laser power	pyroplotter	FlashCut CNC	0	10-15-2007 09:46 PM
How to replace Bandit controler.	gitit1941	General Metal Working Machines	5	02-05-2007 09:59 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)