4x8 Icon Table Purchase.

[Pure-Powder]

I purchased a 4x8 Icon series table with a water table and A80 Thermal Dynamics from http://www.fastcutcnc.com/index.php will take delivery on or about March 10 , 2010 so far my purchase has been A1.. As things progress I will keep everyone up on how things are going. Will post pictures of the table when it arrives as well as some video of the table cutting.. I would not hesitate to recommend Fast Cut at this time as they are real quick to return my calls as well as update me on my table build.
Thanks Dennis

[Ben Olson]

We have a G6 fabricator 4x10 with a water table at work that we are just getting on line, so far so good. It seems like a fairly solid unit

[Pure-Powder]

Ben nice to see there are others out there using FastCut products.. I looked at there G6 it is a real nice looking machine.. A little more than I needed for my hobby.. If you get a chance post a few pics of your setup.

Thanks Dennis

[Pure-Powder]

Ben you up and cutting yet! How about a few pics of your set up.

[Pure-Powder]

Table update - Was contacted by Fastcut and my table is ready to go.. I will try and get down to there Facility and have a run through on the table later in the week and also arrange shipping. Will be taking my camera along for the ride to take a few pictures .. Will post them as soon as possible!

[Pure-Powder]

Picked up my table yesterday , all went well. Will post more pics when i get it set up with the water table and such.

[Pure-Powder]

Well table is now off the trailer and into the shop.. Have to wait for the Electrician.

[Pure-Powder]

Well after a little mishap... I really have to say this machine is bloody great.. The problem I had was with the THC ,which happens to be Tom's from CandCnc, Not sure if was Toms product or not, but the THC was wired backwards so I blow up my first torch cap before finding out the problem. The torch wanted to climb away from the plate. Switched out the wires on the little blue box and all was well...

Now for the good stuff , this table is just great...the speed and smooth movement is bar none. Compared my old table to my new Fastcut table is like Corvette to a Chevette.

Soon as I figure out my Video function on the new cell phone I will post a video.

I just have to say thanks to Russell and Carlos of Fastcut for a great response when it was needed, there support is A1 in my books....

Also there table was a great value for the money.. I would highly recommend these guy... Wish I would have found you before I purchased my first table!

Thanks Dennis

[Edwardo]

Nice looking table, i like the way the tray slides in... at one point in time i was going to do something simular with my table, i may still do it eventually.

EDD

[Ben Olson]

Originally Posted by Pure-Powder Ben you up and cutting yet! How about a few pics of your set up.

I'll see if I can snap a few pix of the table , we are up and cutting , with a few hiccups along the way , it seems some components needed to be changed in the control computer for optimal performance . but fastcut was on top of it and handled it promptly , Nice looking table you have there though , For your water table may I suggest using Greencut , we use it on ours and it works great, no rust and non toxic/biodegradeable

[Pure-Powder]

Ben , where are you getting your greencut from.. and what is the price! Looking forward to your pictures.

Thanks Dennis

[jon-tis]

Originally Posted by Pure-Powder Ben , where are you getting your greencut from.. and what is the price! Looking forward to your pictures. Thanks Dennis

We get our Greencut here:

http://www.jbox.ca/lubricants/

Cheers,
Jon