Need Help!- Downloading to Nakamura Slant 1 w/ Fanucc11TE

[tp176]

We have purchased a used Nakamura-Tome Slant 1 and didn't get all the manuals - we are in process of obtaining them now. Can someone describe in detail how to download a program via rs232? Please include screen info/buttons.

[RBrandes]

Originally Posted by tp176 We have purchased a used Nakamura-Tome Slant 1 and didn't get all the manuals - we are in process of obtaining them now. Can someone describe in detail how to download a program via rs232? Please include screen info/buttons.

Do you still need help? Or did you get your manuals by now? I have a Slant 1 with the 10T control. Not the same, but it may be close. Perhaps I can help.
Regards, Ray

[tp176]

Yes, still need help. The manual is still one week away.

[RBrandes]

I use a Windows program called SE DNC
In it I set the communication parameters to match those in the lathe.
To access the parameters in the Fanuc 10T,
Select MDI using the rotary switch

With the hot keys under the monitor, Punch "Settings", "Chapter", "General"
Get to #8000 and set the last bit to "1", an alarm will flash.
Page up and down until you find your RS232 params and I suggest to copy them, rather than change anything yet.
Go back to #8000 and set bit 8 to "0".
Set your PC communication params to match the controls.
Then Select Program using the rotary switch
On the hot keys punch hit the "+" until you see "Read".
Punch "Read", "one", "new"

Then initiate the send from your PC.



I hope this helps.
Regards, Ray

[tp176]

Thanks, I'll try it later today.